Metronome

The metronome provides an easy way to generate a metronome track as a timing basis for your song. The typical click sounds are generated according to the selected configuration.

Configuration

The following parameters are available to configure the metronome.

Tempo
[30 - 300 BPM]
Set the tempo of the sequence in BPM (beats per minute). Each beat is a click sound in the metronome track.
Start delay
[1 - 10 sec]
Insert silence for the specified duration at the beginning of the track.
Beats per bar
[1 - 16]
Set the number of beats of each bar. E.g. for 3/4 measure set “3”.
Number of bars
[1 - 500]
Set the number of bars you want to be generated.
Accent on first beat of bar The metronome sound for the first beat of each bar is accentuated by a higher frequency and level.

Directly below the settings, the resulting duration of the track is displayed.

Again below that is the field where you can tap the beat. The measured tempo is then displayed at the top in the corresponding field.

Once you've set everything up, you'll need to tap the “OK” button in the top right corner to generate the track.